Expert By Facom Punches

Expert By Facom Punches at MyToolShed.co.uk

Expert By Facom punches are hand tools for marking, aligning and driving in metalworking, engineering and workshop maintenance. They are available as centre punches and parallel punches, so you can mark a drilling position, tap out a pin or line up components during assembly.

Each type suits a different stage of the job. Whether you are a fabricator, fitter, mechanic or maintenance engineer, you can choose the punch that matches your task at MyToolShed.co.uk.

Expert By Facom Punches Features and Benefits

• Hardened steel construction: The tips hold their shape under repeated hammer blows, so marks stay crisp and the tool lasts longer between replacements.
• Precisely ground points and faces: Accurate tips give clean, well-placed marks, helping drill bits start on target and reducing wandering on hard surfaces.
• Knurled or textured shanks: A secure grip helps keep the punch steady when you are working with oily or gloved hands.
• Struck-end design: The head is shaped to take hammer strikes, which gives a controlled transfer of force and helps limit mushrooming over time.
• Task-specific shapes: Separate centre and parallel designs mean you use the right tool for marking or driving, rather than compromising with a makeshift alternative.

Popular Expert By Facom Punches

Centre Punches

Centre punches create a small indentation in metal before drilling. The dimple guides the drill bit and stops it slipping, which is essential for accurate hole positioning in steel, aluminium and other metals. They are also useful for general layout marking on fabrication and repair work.

Parallel Punches

Parallel punches, often called pin punches, have a uniform shaft along their length. They are used to drive out roll pins, dowels, rivets and locating pins from machinery, linkages and assemblies. The straight shank keeps force in line with the pin, which helps prevent bending or damage to the surrounding hole.

Frequently Asked Questions

How do I choose between a centre punch and a parallel punch?

Choose a centre punch when you need to mark a point on a surface, typically before drilling. Choose a parallel punch when you need to drive a pin or similar fixing out of a hole. Pick a parallel punch with a tip slightly smaller than the pin diameter so it pushes the pin out without catching the edges of the bore.

How should I use a centre punch for accurate drilling?

Mark your position, then place the tip on the point and hold the punch upright. Strike the head firmly with an engineer's hammer to form a clear dimple. Check the mark is in the correct place, and strike again if the surface is hard. The dimple will then locate the drill bit and help you start the hole cleanly.